What is the process of starting the injection molding machine? If the process of starting the injection molding machine is not standardized, it will lead to poor mass production, short machine life, quality decline and other conditions. The operator must be familiar with the function of each switch button on the equipment operation panel, and operate in strict accordance with the operating procedures and precautions. Next, I will explain to you the process of starting the injection molding machine. Teach you to standardize the process

1. Before heating the machine and starting production, open the cooling water valve and observe whether the water channel is unobstructed.

2. Close the power switch on the side of the control box, turn on the internal power supply, and press the motor start button on the panel to start the oil pump motor.

3. For the machine that is used for the first time or has not been used for a long time, after the oil pump is started, the operation can be started only after a few minutes of empty running.

4. Turn on the barrel heating switch, switch on the electric heating power supply, adjust the thermostatic nozzle and temperature controller on the door of the box, set the temperature, and observe the current of the ammeter to determine whether the electric heating coil is good or not.

5. The test run shall be carried out from manual half automatic to full automatic in sequence, and the important fastening bolts shall be checked for looseness

Abnormality shall be stopped immediately. After confirming that it is normal or troubleshooting, the test run shall be carried out again.

6. When the processing is stopped or the material is changed, the material cylinder shall be cleaned. The cleaning work shall be carried out under the condition that the material cylinder is heated. After the cleaning is completed, the heating switch shall be turned off immediately. The cleaning work is particularly important for the processing of easily decomposed plastics

7. When the processing stops, first turn the action operation switch to the manual position, and other action switches to the OFF position, turn the barrel heating switch to OFF, press the motor stop button to turn off the oil pump motor, and finally turn off the power switch to end the work.

The above content is an introduction to the process of starting the host. I hope it can help you.